This is an assignment paper for the subject Industrial Electronics ( Telecommunication engineering), It is important for the writer to conduct the designs on a software program exp: (Multisim or tinkercad) and demonstrate the results clearly with screenshots. I will not accept writer submissions if they don’t contain these results

Assignment Tasks

• Calculate the output voltage 𝑉_𝑜 for circuit shown in figure below

                                                                                                                                (20 Marks)

• Design an op-amp circuit with resistors not less than 10 kΩ that will produce an output voltage of

𝑉_𝑜𝑢𝑡 = 8𝑉₁ + 12𝑉₂ − ∫(5𝑉₂ + 6𝑉₁₎𝑑𝑣                                                                                               (25 Marks)

[Use minimum number of op amps]

• Design and set up an Operational Amplifier IC based Practical differentiator to differentiate an ac input signal of frequency, 𝑓_𝑎=1kHz (The frequency at which gain is 0 dB)
  • Feed a Square wave of 2Vpp, 1ms .Observe and plot the output waveform
  • Feed a triangular of 2Vpp, 1ms . Observe and plot the output waveform
  • Feed a Sine wave of 2Vpp, 1ms. Observe and plot the output waveform. Also plot gain Vs

Frequency curve for frequency range from 100Hz to 1MHz  Write a Reflection on the results obtained.

    (25 Marks)

[Note: This is Lab based question. Design of the circuit and simulation using Multisim or Tinkercad is expected. Draw the different inputs and their corresponding outputs with proper scale, on a normal graph.). Also plot Gain Vs Frequency curve for frequency range from 100Hz to 1MHz for a sinusoidal input on a semilog graph.

For drawing graphs you can use paint]

• An oven is designed to set to work at a maximum temperature of 200⁰ The oven has 4 independent heating coils in the four sides, which is calibrated as 10⁰C of temperature change produced 1mV

(1mV=10⁰C). Design a circuit to blink an LED and trigger an alarm, if the operating temperature exceeds 200⁰C under the given calibration of 1mV=10⁰C.  It is assumed that there is no need to buffer

the heating coil voltage signals.                                                                                                               (30 Marks)

[Note: This is Lab based question. You are expected to draw the circuit diagram, do design calculations and perform simulation using Multisim or Tinkercad for verifying the results.]

Rules & Regulations:

• All resources should be cited using CU Harvard style.
• The final assignment must have a Title page, Table of Contents, References/ bibliography using CU Harvard Style and page numbers.
• Title Page must have Assignment Name, Module name, Session, your name, ID, and the name of the faculty.
• Softcopy in word format is to be submitted through Turnitin link on Moodle.
• Viva will be conducted after the assignment submission as per the dates informed earlier.

<Below given guidelines are only suggestive. It may be edited as per the needs of the assignment/module>

• Assignment must be computer typed.
  • Font – Times New Roman
  • Font – Style – Regular
  • Font – Size – 12
  • Heading should be with Font Size 14, Bold, Capital and Underline.